Recommended starting specification
| Recommended panel | Matched to process, finish, exposure and compliance route. |
|---|---|
| Density | Defined by door/body construction and hardware. |
| Typical thickness | Common enquiry: 16 / 18 / 25 mm. |
| Surface | Smooth, calibrated faces; exact sanding and tolerance confirmed by SKU. |
| Emission / certification | Confirm destination requirement and current evidence for the offered SKU. |
| Trial | Approve machining, pressing or finishing on the buyer’s actual process before recurring orders. |
Why the process fails
Steam, sink-zone leaks, open edges and unsuitable hardware design can cause swelling or fixing failure.
What the buyer should verify
- Cabinet body or routed door
- Wet-zone exposure and edge sealing
- Surface, hardware and emission class
Selection rationale
MR MDF can reduce humidity risk in suitable interior use, but detailing and edge protection remain essential.
Panel routes kitchen factories usually enquire
Paneltiva supplies panels only for cabinet manufacturers — not finished kitchen units.
- Melamine MDF / TFL — decorative faces (including Walnut / Oak woodgrain), with B/S or O/S stated on enquiry; thicknesses such as 9 / 12 / 18 mm; sheet formats 4 × 8 and 4 × 9 (4 × 9 subject to order confirmation). Full décor / face / substrate detail: Melamine MDF.
- MR MDF substrate — when carcasses or components face humid interior conditions; seal edges and confirm grade. Detail and vanity-adjacent humid use: Moisture Resistant MDF. Melamine on an MR core is a common humid-kitchen enquiry — state substrate + décor together.
- Emission routes (e.g. E1) are matched per SKU / order confirmation.
