Skip to content
Quote
Menu

Application decision page · Processing

MDF for Powder Coating

Select MDF for conductivity, moisture profile, heat cycle, edge quality and coating adhesion.

Recommended starting specification

Recommended panel Matched to process, finish, exposure and compliance route.
Density Process-specific density and moisture profile required.
Typical thickness Common enquiry: 12 / 18 / 25 mm.
Surface Consistent surface and sealed/machined edges validated in the actual line.
Emission / certification Confirm destination requirement and current evidence for the offered SKU.
Trial Approve machining, pressing or finishing on the buyer’s actual process before recurring orders.

Why the process fails

Poor conductivity, gas release, moisture variation and porous routed edges can create weak transfer, pinholes, orange peel or adhesion loss.

What the buyer should verify

  • Preheat and cure temperature/time
  • Powder chemistry and target film
  • Moisture conditioning and edge preparation

Selection rationale

Powder-coating suitability must be proven on the buyer’s exact preheat, spray and cure cycle.

WhatsApp